We use cookies to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners who may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. You consent to our cookies if you continue to use our website. Our policy.

 

lv LV ru RU en EN +371 2004 2004
Main page Аll products Series windows Windows and doors in the warehouse Metal doors Blinds Contacts
All products

*Product can differ from image

PENOSIL Premium Fast Foam 2K quick-curing two-component straw foam

PRODUCT DESCRIPTION
PENOSIL Premium Fast Foam 2K is a two-component foam for fast and mechanically strong insulation, installation and filling works.

------------------------------

VALUES
  • Low post-expansion.
  • Very good adherence on various building materials.
  • High thermal and sound insulation.
  • Cured foam is a good temperature and sound insulator.
  • Thick and even structure.

------------------------------

APPLICATION AREAS
  • Filling areas that are difficult to access or require mechanical strength.
  • Insulation of gaps and penetrations.
  • Insulation of vehicles, containers or equipment.
  • Gluing of window sills.
  • Single-point installation of doors.
ADHERES TO
  • Wood
  • Concrete
  • Stone
  • Plaster
  • Metal
  • PVC
  • Polystyrene
PACKAGE

Aerosol can 650 ml,
content 400 ml.
12 cans in a box

------------------------------

USAGE INSTRUCTIONS

Before use, remove the protective cap from the valve and turn the adapter onto it. For the internal cylinder to be activated, the actuator propeller on the bottom of the cylinder needs to be turned at least 6 times in the direction of the arrow.

Then shake the canister well at least 30 times in order for components A and B to mix properly. If the can is cold, shake more (the foam quality depends on the result of shaking). Immediately turn the can upside down and begin applying foam, or else the temperature inside the can may rise over +50 °C and result in the risk of explosion. After turning the disc, you have approximately 5 minutes to use the foam; after that, any foam left inside the canister will cure. Hold the can upside down and adjust the foam output by pressing the valve. Foam should be evenly light green color. If it is not, shake the canister again and continue to apply the foam.

Fill the gap only partially, since the foam will expand. Gaps of any size may be filled, since the foam does not require air humidity to cure. There are no constraints on the volume or diameter of joints or gaps.

------------------------------

TIPS
  • Air temperature during use: +5 °C to +30 °C, best results at +20 °C.
  • Can temperature before activation: +10 °C to +25 °C, best results at +20 °C. The can has to be cooled down in water if the temperature of the can exceeds +25 °C.
  • The surfaces must be clean from dust, loose particles and oil.
LIMITATIONS
  • Once the two component curing system has been activated, heat is released; for this reason, the content of the can needs to be used within 5 minutes. If the can is not emptied completely or if its temperature exceeds +25 °C before activation, there is a risk of explosion of the can.
  • The foam does not adhere to Teflon, polyethylene and silicon surfaces. Cured foam is sensitive to UV-light and direct sunlight and therefore must be covered with suitable opaque sealant, filler, paint or other material.

 

SPECIFICATION